To Mount The P2 Drive In A Personal Computer 5-Type Bay - Panasonic AJ-PCD35уо Operating Instructions Manual

Installation

To Mount the P2 drive in a Personal Computer 5-type Bay

1
After switching the personal computer off,
remove the power cable from the personal
computer.
2
After checking that the personal computer
is off, remove the cover from the personal
computer.
3
Put the PCI Express cable included with
the P2 drive through the notch in the board
bracket about 20 cm from the cable
connector.
About 20 cm
Notch
Put the cable in from above.
4
Attach the PCI Express cable with the
cable stop on the top of the PCI Express
board base plate.
5
After passing the PCI Express cable
through the slot attaching the PCI Express
board, insert the PCI Express board into
the PCI Express connector inside the
personal computer.
<Notes>
Install the PCI Express board with the
PCI Express connector. Installing with
an ordinary PCI connector may cause
damage to the personal computer.
Since the included PCI Express board
uses a full height bracket, it cannot be
installed in a low-profile slot.
(continue)
Cable stop
PCI Express
connector
(for example)
If you are unable to pass the PCI
Express cable through the slot on your
personal computer, the P2 drive cannot
be mounted in the 5-type bay. In this
case, use the P2 drive as an external
drive.
6
Firmly attach the PCI Express board to the
personal computer with the screws etc
included with the personal computer. The
PCI Express cable will extend about 20 cm
from the connector to the exterior of the
personal computer.
7
Connect the PCI Express cable to the
PCIe interface connector of the PCI
Express board. After connecting the cable,
tighten the screws on the connector to
firmly attach the connector. Bend the cable
so that it loosely arcs between the area
connected to the board and the notch. If
the cable is bent sharply, it may
disconnect.
8
Undo the six screws and remove the
cover.
DC IN 16V
DC IN 12V
Cover
13