Changing The Initial Needle Stop Position - Baby Lock Crafter's Choice BLCC2 Instruction And Reference Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
SEWING BASICS
3 Position the fabric under the presser foot, and
then press
/
once.
1
1 "Start/Stop" button
After reverse/reinforcement stitches are
sewn, the machine starts sewing.
4 After reaching the end of the stitching, press
("Reverse/Reinforcement Stitch"
button) once.
This step is not necessary if a stitch such as
those for sewing buttonholes and bar tacks is
selected where reinforcement stitches are
automatically sewn.
1 "Reverse/Reinforcement Stitch" button
After reverse/reinforcement stitches are
sewn, the sewing machine stops.
Memo
● Reverse/reinforcement stitches WILL NOT
be sewn until
Stitch" button) is pressed.
Stop" button) may be pressed to stop
stitching when needed such as for pivoting
corners.
50
("Start/Stop" button)
1
/
("Reverse/Reinforcement
("Start/
/
Changing the initial needle
stop position
The needle position when the machine is turned on
can be switched between a position on the left or at
the center.
While holding pressed the
1
(tens) from the stitch selection keys, turn on
the sewing machine.
1
1 Up key for the first digit (tens) from the stitch
selection keys
The needle position switches between that
on the left and that at the center.
• Each time the operation described in step
is performed, the needle position switches
between that on the left and that at the
center.
Memo
● As a default, the initial needle stop position
is on the left.
● The specified initial needle stop position is
maintained even after the machine is turned
off.
for the first digit
1