Baby Lock Crafter's Choice BLCC2 Instruction And Reference Manual page 23

5 Lightly hold down the bobbin with your right
hand, and then guide the thread as shown
with your left hand.
CAUTION
●
When installing the bobbin, be sure to
hold it down with your finger. If the
bobbin is not correctly installed, the
thread tension will be incorrect.
6 Pass the thread through the slot as shown, and
then pull the thread out toward the front.
1
1 Cutter
The cutter cuts the thread.
Note
● Make sure that the thread is correctly
inserted through the tension-adjusting
spring of the bobbin case. If it is not inserted
correctly, reinsert the thread.
1 Tension-adjusting spring
1
7 Reattach the bobbin cover.
Insert the tab in the lower-left corner of the
bobbin cover, and then lightly press down on
the right side.
1
The lower threading is finished.
Next, thread the upper thread. Continue with
the procedure in "Upper Threading" (page 22).
Memo
● You can begin sewing without pulling up
the bobbin thread. If you wish to pull up the
bobbin thread before starting to sew, pull
up the thread according to the procedure in
"Pulling up the bobbin thread" (page 29).
Winding/Installing the Bobbin
1
2
21