Threading The Needle Manually (Without Using The Needle Threader) - Baby Lock Crafter's Choice BLCC2 Instruction And Reference Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
GETTING READY
Note
● If the needle was not completely threaded,
but a loop in the thread was formed in the
eye of the needle, carefully pull the loop
through the eye of the needle to pull out the
end of the thread.
CAUTION
●
When pulling out the thread, do not pull
it with extreme force, otherwise the
needle may break or bend.
5 Raise the presser foot lever, pass the end of
the thread through the presser foot, and then
pull out about 5 cm (2 inches) of thread
toward the rear of the machine.
1
1 5 cm (2 inches)
The upper threading is finished.
Now that the upper threading and the lower
threading are finished, you are ready to
begin sewing.
Note
● If the needle is not raised, the needle
threader cannot thread the needle. Be sure
to press ("Needle Position" button) to
raise the needle before using the needle
threader.
26
Threading the needle manually
(without using the needle threader)
When using special thread, thread with a thickness
of 130/20 or thicker, the wing needle or the twin
needle which cannot be used with the needle
threader, thread the needle as described below.
1 Thread the machine to the needle bar thread
guide.
• For details, refer to "Upper Threading"
(page 22).
2 Lower the presser foot lever.
1 Presser foot lever
3 Pass the thread through the eye of the needle
from front to back.
4 Raise the presser foot lever, pass the end of
the thread through the presser foot, and then
pull out about 5 cm (2 inches) of thread
toward the rear of the machine.
1