Before Use; How To Attach The Tip Tool - Hitachi GP10DL Instruction Manual

English
○ Regarding the temperature of the rechargeable
battery.
The temperatures for rechargeable batteries
are as shown in the table below, and batteries
that have become hot should be cooled for a
while before being recharged.
Rechargeable
batteries
BCL1015
○ Regarding recharging time
Table 4 shows the recharging time required
according to the type of battery.
Table 4 Recharging time (approx. min.) at 20°C
Battery
voltage (V)
10.8 BCL1015
NOTE
The recharging time may vary according to the
ambient temperature and the power supply
voltage.
4. Disconnect battery
receptacle.
CAUTION
Do not pull the plug out of the receptacle
by pulling on the cord.
Make sure to grasp the plug when removing
from receptacle to avoid damaging cord.
5. Remove the battery from the battery charger.
Supporting the battery charger with hand, pull
out the battery from the battery charger.
How to make the batteries perform longer
○ Recharge the batteries before they become
completely exhausted.
When you feel that the power of the tool
becomes weaker, stop using the tool and
recharge its battery. If you continue to use the
tool and exhaust the electric current, the battery
may be damaged and its life will become
shorter.
○ Avoid recharging at high temperatures.
A rechargeable battery will be hot immediately
after use. If such a battery is recharged
immediately after use, its internal chemical
substance will deteriorate, and the battery
life will be shortened. Leave the battery and
recharge it after it has cooled for a while.
16
Table 3
Temperatures at which the
battery can be recharged
32°F – 122°F (0°C – 50°C)
Battery capacity (Ah)
1.5 Ah
40 min.
charger from
CAUTION
● When the
continuously used, the battery charger will
be heated, thus constituting the cause of
the failures. Once the charging has been
completed, give 15 minutes rest until the
next charging.
● If the battery is charged while it is heated
because it has been left for a long time
in a location subject to direct sunlight or
because the battery has just been used,
the pilot lamp of the charger lights for 1
second, does not light for 0.5 seconds (off
for 0.5 seconds). In such a case, fi rst let
the battery cool, then start charging.
● When the pilot lamp fl ickers (at 0.2-second
intervals), check for and take out any
foreign objects in the charger's battery
installation hole. If there are no foreign
objects, it is probable that the battery or
charger is malfunctioning. Take it to your
authorized Service Center.
● If the battery charger does not work while
the battery is mounted correctly, it is
probable that the battery or charger is
malfunctioning. Take it to your authorized
the
Service Center.

BEFORE USE

Check the work area to make sure that it is clear of
debris and clutter.
Clear the area of unnecessary personnel. Ensure
that lighting and ventilation is adequate.

HOW TO ATTACH THE TIP TOOL

WARNING
To prevent accidents, be sure to switch the
power off and remove the battery from the
grinder.
CAUTION
Make sure the mandrel is screwed in
tightly.
After attaching the tip tool, check that the
tool is securely fi xed.
If the tool is loose, it may come off , causing
damage or injury.
1. How to use the screw-type mandrel (Fig. 7 (a))
Use the screw-type mandrel when using the felt
polishing wheel.
battery charger has been