Advertisement
2940UWPro-ig.qxd
12/21/98 9:55 AM
Computers with Windows 95/Windows 98
Turn on all external devices and then the computer. Windows
S
1
TEP
95/98 now will recognize the SCSI Card 2940UW Pro installed
in your computer and will install the software driver for it.
N
OTE
into the CD-ROM drive. Follow the instructions that appear
onscreen.
If prompted, restart your computer to finish setting up your
S
2
TEP
new hardware.
Click the Start button, point to Settings, then click Control
S
3
TEP
Panel.
Double-click the System icon.
S
4
TEP
Click the Device Manager tab.
S
5
TEP
Double-click the SCSI Controller icon. The driver for the SCSI
S
6
TEP
Card 2940UW Pro is listed as the "Adaptec AHA-2940UW
Pro/AIC-788x PCI SCSI Controller."
• If the driver is listed, the driver is loading properly.
• If the driver is listed but has an exclamation mark inside a
yellow circle, the driver is in a problem state (usually a con-
flict with other hardware using the same resources).
• If the driver is listed but has an "X" inside a red circle, the
driver is disabled and isn't loading.
• If the driver is not listed or is not loading properly, see the
SCSI Card 2940UW Pro User's Reference for troubleshooting
information.
• If the SCSI Controller icon or the SCSI Card 2940UW Pro
driver is not listed, try reinstalling the driver.
N
OTE
SCSI Card 2940UW Pro User's Reference for troubleshooting
information.
Page 8
You may be asked to insert the Windows 95/98 CD-ROM
If the driver is not listed or is not loading properly, see the
8
Advertisement
