Advertisement
2940UWPro-ig.qxd
12/21/98 9:55 AM
Connect each additional SCSI device to the previous one until
S
4
TEP
all devices are connected. The device at the end of the chain
must be the only external device terminated.
Connect all power cables to the external devices and
S
5
TEP
computer.
Continue with the
next section to install
the SCSI Card
2940UW Pro software
driver for your operat-
ing system.
N
OTE
a termination problem if a 68-pin to 50-pin adapter is not used.
I
NSTALLING THE
S
OFTWARE
To install the SCSI Card 2940UW Pro software (software driver),
go to the section below for the operating system (for example,
Windows ® 95) installed on your computer. If the operating sys-
tem is not yet installed, install it now. Refer to your operating
system documentation for instructions.
N
OTE
running Windows or DOS, you will need to partition and format the
drive with the DOS
Refer to your Windows and DOS documentation for instructions.
Page 7
Terminated SCSI Device
A narrow external device at the end of the chain may cause
SCSI C
2940UW P
ARD
If you have installed a new SCSI hard drive in a computer
f f d d i i s s k k and f f o o r r m m a a t t commands before it can be used.
(Continued on the other side)
7
RO
Advertisement
