Starting The Applications; Starting Fault Management; Starting From The Network Map - AT&T OneVision DEFINITY G3 Fault Management Installation And Integration Manual
Integration for at&t onevision
Hide thumbs
Also See for OneVision DEFINITY G3 Fault Management:
- User manual (153 pages) ,
- Installation and integration manual (60 pages) ,
- Management manual (10 pages)
Table of Contents
Advertisement
Starting the Applications
This chapter provides information for
Starting Fault Management
Starting Fault Management's online user guide
This chapter assumes you have already installed the Fault Management
application and added DEFINITY G3 nodes to your map, as described in
Chapter 2 and Chapter 3. If not, complete the procedures in those
chapters before you continue.
Starting Fault Management
Network map
Mouse
Starting from the Network Map
Follow these steps to start Fault Management from the network map.
1. At the appropriate map, select the icon for which you want to run Fault
Management.
2. At the menu bar on the same map, select Monitor, then select
DEFINITY.
Issue 1 October 1995
4
4-1
Advertisement
Table of Contents
Need help?
Do you have a question about the OneVision DEFINITY G3 Fault Management and is the answer not in the manual?