Installation And Setup Task List - AT&T OneVision DEFINITY G3 Fault Management Installation And Integration Manual

Installation and Setup Task List

Installation and Setup Task List
This section provides a list of tasks, in the recommended order, to perform
while installing and setting up Fault Management. Use this list to check off
your installation activities as you complete them. You may want to make
your own task list based on this one, and include persons or organizations
responsible and dates to be completed.
NOTE:
These procedures assume that installation of OneVision
Management Solutions DEFINITY G3 Proxy Agent has occurred or
will occur shortly. You can install Fault Management without the
Proxy Agent being installed, but without the Proxy Agent up and
running properly and until the full connectivity is established, the
NMS will not receive any PBX data. Furthermore, communication
between the Proxy Agent and Fault Management requires
correlation between values in specific fields on the Proxy Agent
and NMS administration. Therefore, you should plan some
coordination for installing these two applications.
Verify the environment is correct (Chapter 1)
Make sure you have the required operating system and network
connectivity already set up.
Verify hardware (Chapter 1)
Make sure you have all the required hardware and that the hardware
meets the certification requirements. Also make sure you have enough
space on the hard drive.
Verify existing software (Chapter 1)
Make sure the versions of your operating system and the NMS are
correct
Issue 1 October 1995
1-5