Requirements For Fault Management Installation; Certified Hardware - AT&T OneVision DEFINITY G3 Fault Management Installation And Integration Manual

Integration for at&t onevision

Hide thumbs Also See for OneVision DEFINITY G3 Fault Management:

Table of Contents

Requirements for Fault Management Installation

Requirements for Fault

Management Installation

In order for Fault Management to be installed and to run properly, your

NMS must be set up with the following:

AT&T OneVision Network Node Manager Release 3.3

AT&T GIS workstation that meets all hardware requirements of the AT&T

OneVision Network Node Manager Release 3.3 software

The SVR4 version 3 operating system

The shared library lib c

A 1/4-inch tape drive

20 MB of random access memory

At least 28 MB of free space on the hard drive

The approximate amount of disk space required by Fault Management is 24

MB.

Fault Management is designed to run on any computer hardware and

operating system that is certified to run your AT&T OneVision Network Node

Manager Release 3.3.

Issue 1 October 1995

1-7

Table of Contents

Do you have a question about the OneVision DEFINITY G3 Fault Management and is the answer not in the manual?