AT&T OneVision DEFINITY G3 Fault Management Installation And Integration Manual page 24

Integration for cabletron spectrum on a sunos

Hide thumbs Also See for OneVision DEFINITY G3 Fault Management:

Table of Contents

Installation

Incorporates the DEFINITY G3 MIB into the existing MIB and

updates the database

Installs the DynaText online documentation

NOTE:

The installation takes a few minutes. While you are waiting, you

can use the following steps to check on its progress. These steps

are optional.

When the installation finishes, the following message displays:

Install completed successfully

5. Click OK to clear the message from your screen.

6. Click Exit on the Installation Configuration screen.

Result: A message box asks you to verify the exit command.

7. Click OK.

8. Restart SpectroSERVER and SpectroGRAPH.

SEE ALSO:

If you need help restarting SpectroSERVER and SpectroGRAPH, see

your System Administration Guide.

Issue 1 April 1996

a. On the Installation Configuration screen, select the host line.

b. Click on Host Detail.

Result: A pop-up window displays messages that either describe

the current process or alerts you to a processing error.

c. Click OK to close the window and return to the Installation

Configuration screen.

Table of Contents

Need help?

Do you have a question about the OneVision DEFINITY G3 Fault Management and is the answer not in the manual?