AT&T OneVision DEFINITY G3 Fault Management Installation And Integration Manual page 18

Before You Begin
Prepare for software installation
Do you have the Fault Management DEFINITY G3 Fault
Management Release 1.2 tape?
Plan for the time needed to install the software (about
Install the software (Chapter 2)
Make changes to the environment, such as updating the PATH variable
(Chapter 2)
Restart your NMS
Add the DEFINITY PBXs as nodes on the NMS
(Chapter 3)
Add the Proxy Agent(s) as a node(s) on the NMS
(Chapter 3)
Run Fault Management from the ap propriate menu on your NMS
(Chapter 4). Verify that Fault Management
Executes properly
Is receiving data from the Proxy Agent
Run the Test INADS command on the PBX to test alarm reception (if
applicable)
Customize Fault Management
Change polling intervals
Change user-interface characteristics
SEE ALSO:
For instructions on customizing Fault Management, refer to the
Network Management Solutions DEFINITY G3 Fault Management user
guide.
Run the online guide to verify it is installed and executes correctly
(Chapter 4)
6
Issue 1 April 1996
½
hour)