Verifying Connectivity; Icon State; Startup Messages - AT&T OneVision DEFINITY G3 Fault Management Installation And Integration Manual

Integration for cabletron spectrum on a sunos

Hide thumbs Also See for OneVision DEFINITY G3 Fault Management:

Table of Contents

Alarm States

Verifying Connectivity

You can use the following features to verify that the Proxy Agent is

connected to a PBX:

Icon states

Fault Management startup messages

Warning messages

Data refreshes

The Management Information Base (MIB)

The DEFINITY G3 Proxy Agent maintains continuous contact with the

DEFINITY PBXs that it serves. When the Proxy Agent and the PBX are

connected, you can determine the status of the PBX by viewing the

DEFINITY icons on the network map.

If the Proxy Agent is not in contact with the PBX, the state of the DEFINITY

icon is Unknown.

You can verify connectivity when you start Fault Management from the

following screens:

Startup

Switch View

Issue 1 April 1996

Table of Contents

Do you have a question about the OneVision DEFINITY G3 Fault Management and is the answer not in the manual?