AT&T MERLIN 410 Administration Manual page 41

Quick Reference Guide (continued)
ADMINISTERING OTHER SYSTEM OPTIONS (continued)
Group Paging
(See page 24.)
Transfer Return
(See page 25.)
Button-Free Line Operation
(Use with Model 820 5-button voice terminals with five or
more lines.)
(See page
25.)
System Reset
(See page 27.)
40
Procedure
Instructions For Use
• Dial a Group Page code ( 70 through 79) depending on which
of the ten groups you want to administer. (You can assign no more
than three phones to each group.)
• Touch the intercom Auto Dial button for the voice terminals you
want to include or do not want to include in the group:
Green light off = voice terminal is in the group
Green light on = voice terminal is not in the group
• Touch Administer (Send Message) when you are finished with
that group.
• Administer a different group by repeating the above procedure
again.
• Dial a code ( 21 through
and 29 gives you nine rings. You can turn off Transfer Return
by dialing 20.
To administer a voice terminal to be button-free:
• Touch the Intercom Auto Dial button of the voice terminal you want
to administer. (The green light next to the button comes on.)
If you want the button-free voice terminal to ring, dial
•
green light flashes rapidly). If you don't want the voice terminal
to ring, dial 32 (the green light flashes slowly).
To return a voice terminal to "square" operation:
• Touch the Intercom Auto Dial button of the voice terminal you want
to administer.
• Dial 34.
• At the control unit, set the Admin/Normal switch to Admin.
• At the administration/attendant voice terminal, slide the T/P switch
to P .
• Touch Administer (Send Message).
• At the control unit, set the Admin/Normal switch to Normal.
• At the administrator/attendant voice terminal, dial
(If you hear a two-beep signal, the reset worked; if you hear a
single, low-pitched ring, the reset did not work.)
• Once the system is reset, turn the power off at the control unit,
then on again.
29), where 21 gives you one ring
99.
31 (the