Interior Vehicle Safety Inspection; Exterior Vehicle Safety Inspection - Chery TIGGO User Manual

If you are required to drive with the
back door open, make sure that all
windows are closed and the climate
control BLOWER switch is set at high
speed. DO NOT use the recirculation
mode.
The best protection against carbon
monoxide entry into the vehicle pas-
senger compartment is a properly
maintained engine exhaust system.

Interior Vehicle Safety Inspection

Seat Belts
Inspect the belt system periodically,
checking for cuts, frays, and loose
parts. Damaged parts must be re-
placed immediately. Do not disas-
semble or modify the system.
Front seat belt assemblies must be re-
placed after a collision. Rear seat belt
assemblies must be replaced after a
collision if they have been damaged
(i.e., bent retractor, torn webbing,
etc.). If there is any question regarding
belt or retractor condition, replace the
belt.
Airbag Warning Light
The light should come on and remain
on for 3-4 seconds as a bulb check
when the ignition switch is first turned
ON. If the light is not lit during start-
ing, see your authorized Chery dealer.
If the light stays on, flickers, or comes
on while driving, have the system
checked by an authorized Chery
dealer.
Defroster
Check the operation by selecting the
defrost mode and place the blower
control on high speed. You should be
able to feel the air directed against
the windshield. See your authorized
Chery dealer for service if your de-
froster is inoperable.
Chery Automobile Co., Ltd.
BEFORE OPERATING YOUR VEHICLE – 29

Exterior Vehicle Safety Inspection

Tires
Examine tires for excessive tread wear
and uneven wear patterns. Check the
tires for the following:
• Stones, nails, glass, or other objects
lodged in the tread
• Tread and sidewall for cuts and cracks
• Proper pressure (including spare)
• Wheel nuts for proper torque
Lights
Have an assistant observe the opera-
tion of exterior lights while you work
the controls. Check turn signal and
high beam indicator lights on the in-
strument panel. Check the following
lights for proper operation:
• Low beam headlights
• High beam headlights
• Turn signals