Jump-Starting Procedures Due To A Low Battery - Chery TIGGO User Manual

• Remove the protective cover from the
positive (+) battery cable, and re-
move the cable.
• Remove the battery hold down, and
remove the battery.
• Install the new battery, when install-
ing the battery, connect the positive
(+) battery cable first and then the
negative (-) battery cable.
• After the new battery is installed, the
vehicle may perform unusually while
driving. This is normal due to the en-
gine control system readapting to the
vehicle's driving conditions.
NOTE: Please discard the used bat-
tery for disposal to an authorized dealer
or local qualified waste disposal station.
Jump-Starting Procedures Due
to A Low Battery
WARNING!
Observe the following guidelines when
jump-starting the battery:
• Take care to avoid the radiator cool-
ing fan whenever the hood is raised.
It can start anytime the ignition
switch is ON. You can be hurt by the
fan.
Chery Automobile Co., Ltd.
IN CASE OF AN EMERGENCY – 105
WARNING!
• Do not attempt to push or tow your
vehicle to get it started. Vehicles
equipped with an automatic trans-
axle cannot be started this way. Un-
burned fuel could enter the catalytic
converter and once the engine has
started, ignite and damage the con-
verter and vehicle. If the vehicle has
a discharged battery, booster cables
may be used to obtain a start from
another vehicle. This type of start
(Continued)
can be dangerous if done improp-
erly, so follow this procedure care-
fully.
• The battery used for boosting must
be 12 volts.
(Continued)