Table of Contents
Advertisement
87V Ex
Users Manual
General Safety Information
The Meter complies with:
EN61010-1:2001
ANSI/ISA S82.01-2004
CAN/CSA C22.2 No. 1010.1:2004
Measurement Category III, 1000V, Pollution
Degree 2
Measurement Category IV, 600V, Pollution
Degree 2
Industrial use in potentially explosive areas of
zone 1 or 2, according to ATEX requirements
(ATEX 137)(see the ATEX safety instructions &
regulations section)
In this manual, a Warning identifies conditions and
actions that pose hazards to the user. A Caution
identifies conditions and actions that may damage the
Meter or the equipment under test.
Electrical symbols used on the Meter and in this manual
are explained in Table 1.
To ensure safe operation of the Meter, fully observe all
instructions and warnings contained in this manual.
ATEX Safety Information
This manual contains information and safety regulations
that must be followed to ensure safe, reliable operation of
2
the Meter in hazardous areas under the described
conditions. Failure to follow the information and
instructions can have dangerous consequences, or may
contravene applicable legislation.
Please take the time to read through this manual before
you start using the Meter.
To ensure safe operation of this Meter, fully observe all
instructions and warnings contained in the manual. In
case of doubt (due to translation and/or printing errors),
refer to the original English manual.
XW Warning
To avoid possible electric shock or personal
injury while working in EX-HAZARDOUS
areas, follow these guidelines:
Do not open the Meter while in an Ex-
hazardous area.
Change the Meter's battery only outside
Ex-hazardous areas.
Do not carry additional or spare batteries
in Ex-hazardous areas.
Use only type-approved batteries in the
Meter. Refer to the "Replacing the Battery"
section for a list of approved batteries.
Do not replace fuses while in an Ex-
hazardous area.
Hide quick links:
Advertisement
Table of Contents
