ECS P33T-A Manual page 24

18
CD_IN: Analog Audio Input connector
Pin
1
CD_L
2
GND
3
GND
4
CD_R
F_USB1~4: Front Panel USB headers
The motherboard has four USB ports installed on the rear edge I/O port array.
Additionally, some computer cases have USB ports at the front of the case. If you
have this kind of case, use auxiliary USB connector to connect the front-mounted
ports to the motherboard.
Pin
1
USBPWR
2
USBPWR
3
USB_FP_P0-
4
USB_FP_P1-
5
USB_FP_P0+
6
USB_FP_P1+
7
GND
8
GND
9
Key
10
NC
Please make sure that the USB cable has the same pin assignment as
indicated above. A different pin assignment may cause damage or system
hang-up.
SATA1~6: Serial ATA connectors
These connectors are used to support the new Serial ATA devices for the highest date
transfer rates (3.0 Gb/s), simpler disk drive cabling and easier PC assembly. It elimi-
nates limitations of the current Parallel ATA interface. But maintains register com-
patibility and software compatibility with Parallel ATA.
Pin
1
Ground
3
TX-
5
RX-
7
Ground
Signal Name
CD In left channel
Ground
Ground
CD In right channel
Signal Name
Front Panel USB Power
Front Panel USB Power
USB Port 0 Negative Signal
USB Port 1 Negative Signal
USB Port 0 Positive Signal
USB Port 1 Positive Signal
Ground
Ground
No pin
Not connected
Signal Name Pin
2
TX+
4
Ground
6
RX+
-
-
Installing the Motherboard
Function
Function
Signal Name