Solutions To Common Problems; F8 Is Displayed; Installation; Entire Oven Does Not Operate - Electrolux 318 200 937 (0411) Rev. A Use And Care Manual

30

Solutions to Common Problems

IMPORT T T T T ANT IMPOR IMPOR IMPOR IMPOR
Before calling for service, review this list. It may save you both time and expense. This
list includes common experiences that are not the result of defective workmanship or
material in your cooktop.
OVEN CONTROL BEEPS AND DISPLAYS F1 THROUGH F10
• Electronic control has detected a fault condition. Push CANCEL pad to clear the
display and stop the display from beeping. Reprogram the oven. If a fault reoccurs,
record the fault number, push the CANCEL pad and contact an authorized servicer.

F8 IS DISPLAYED

• The door was left open and controls set for self-cleaning cycle. Close the door and
push both upper and lower oven CANCEL pads.

INSTALLATION

• Place oven rack in center of oven. Place a level on the oven rack. Contact installing
agent if rack and cabinet cutout flooring are not level.
• Kitchen cabinet misalignment may make oven appear to be not level. Be sure cabinets
are square and level. Contact cabinet maker to correct problem.

ENTIRE OVEN DOES NOT OPERATE

• When the oven is first plugged in, or when the power supply to the oven has been
interrupted, the display will flash. The oven cannot be programmed until the clock is
set.
• Be sure electrical cord is securely connected into the electrical junction box.
• Cord/plug is not installed and/or connected. Cord is not supplied with oven. Contact
your dealer, installing agent or authorized servicer.
• Service wiring not complete. Contact your dealer, installing agent or authorized
servicer.
• Power outage. Check house lights to be sure. Call your local electric company.
• Short in cord/plug. Replace cord/plug.
ANT ANT ANT ANT