Table of Contents
Advertisement
10
Setting Oven Controls
SETTING THE CLOCK
The
or
day operation. The clock has been preset at the factory for the 12 hour operation. When the
range is first plugged in, or when the power supply to the range has been interrupted, the
timer in the display will flash with "PF" (power failure, See Figure 1). Note: The clock
cannot be set when the oven is on.
When PF appears in the display, press
seconds a beep will sounds and PF will disappear.
To set the clock (example below for 1:30):
1. Press
2. Press
Figure 1
appear in the display. Press
start (Figure 4).
Figure 2
Changing between 12 or 24 hour time of day display:
1. Press and hold
down the current time of day will remain and "CLO" will disappear from the
Figure 3
display (Figure 4). CONTINUE holding the pad until a beep is heard.
2. The display will show either "12Hr" (Figure 5) or "24Hr" (Fig.6).
3. Press
The display will show either "12Hr" (Figure 5) or "24Hr" (Figure 6).
Figure 4
4. Press
change.
5. Reset the correct time as described in To set the Clock above. Please note
that if the 24 hour time of day mode was chosen, the clock will now display
Figure 5
time from 0:00 through 23:59 hours.
Figure 6
pad is used to set the clock. The clock may be set for 12 or 24 hour time of
or
. "CLO" will appear in the display (Figure 2).
pads to set the time of day to 1:30 (Figure 3). "CLO" will
or
for 8 seconds (Figure 3). While holding the pad
or
to switch between the 12 and 24 hour time of day display.
or
to accept the change or press
or
. No sound will be heard, but after 10
or
. "CLO" will disappear and the clock will
or
to reject the
Advertisement
Table of Contents
