Charging The Battery - Acer Digital camera 10.1 Mega pixels CCD User Manual

Charging the Battery

Using the optional AC power adapter may charge the battery or operate the camera
as power supply. Make sure that the power of the camera is off and then insert the
battery before starting.
1. Insert one end of the AC power adapter into
the DC IN 5V terminal of the camera.
2. Insert the other end of the AC power adapter
into a wall outlet.
The status LED flashes green when
charging is started and lights green when
charging is completed. The LED lights red
when a charging error has occurred.
It is recommended to fully discharge the
battery before recharging.
Charging time varies according to the
ambient temperature and the status of
battery.
EN-12
This camera must be used with specified AC power adapter. Damage caused
by the use of an incorrect adapter is not covered under the warranty.
Always make sure that the camera is off before removing the battery.
The battery may feel warm after it has been charged or immediately after
being used. This is normal and not a malfunction.
When using the camera in cold conditions, keep the camera and battery
warm by storing it in a warm place such as an interior pocket between shots.
If you open the battery cover without removing the battery, the battery
power will not be disconnected.
If you remove the battery, you have to insert the battery within 2 hours in
order to make sure that the date and time will not be reset.