Charging The Battery - Acer Digital camera 8.28 Mega pixels CCD sensor User Manual

Charging the Battery

Using the optional AC power adapter may charge the battery or operate the
camera as power supply. Make sure that the power of the camera is off and then
insert the battery before starting.
1. Insert one end of the AC power adapter
into the DC IN 5V terminal of the camera.
2. Insert the other end of the AC power
adapter into a wall outlet.
The status LED lights red when
charging is started and goes out
when charging is completed.
It is recommended to fully discharge
the battery before recharging.
Charging time varies according to the
ambient temperature and the status
of battery.
This camera must be used with specified AC power adapter. Damage
caused by the use of an incorrect adapter is not covered under the
warranty.
Always make sure that the camera is off before removing the battery.
The battery may feel warm after it has been charged or immediately after
being used. This is normal and not a malfunction.
When using the camera in cold conditions, keep the camera and battery
warm by storing it in a warm place such as an interior pocket between
shots.
If you open the battery cover without removing the battery, the battery
power will not be disconnected.
If you remove the battery, you have to insert the battery within two
hours in order to make sure that the date and time will not be reset.
EN-13