Route Preferences - Avaya P334T-ML Installation and configuration guid Installation And Configuration Manual

In order to...
Define a default gateway (router)
Remove the default gateway
(router)
Delete all the dynamic routing
entries from the Routing Table
Display information about the IP
unicast routing table
Display a routing table for a
destination address
Display the static routes
Display the number of routes
known to the switch

Route Preferences

The routing table may contain routes from different sources. Routes to a certain
destination may be learned independently from RIP and from OSPF, and at the
same time, a static route can also be configured to the same destination. While
metrics are used to choose between routes of the same protocol, protocol
preferences are used to choose between routes of different protocols.
The preferences only apply to routes for the same destination IP address and mask.
They do not override the longest-match choice. For example, a high-preference
static default route will not be preferred over a RIP route to the subnet of the
destination.
P330 protocol preferences are listed below from the most to the least preferred:
1 Local (directly attached net)
2 High-preference static (manually configured routes)
3 OSPF internal routes
4 RIP
5 OSPF external routes
6 Low-preference static (manually configured routes).
Avaya P334T-ML User's Guide
Chapter 12 Avaya P330 Layer 3 Features
Use the following command...
ip default-gateway
no ip default-gateway
clear ip route
show ip route
show ip route best-match
show ip route static
show ip route summary
137