Technical Details - Beltronics Vector 995 Owner's Manual

Details of Programming
Bands
BandsDFT
In this setting,all North American radar and
laser frequencies are monitored.This is the
factory setting and it is recommended that
you use your V995 in this mode.
BandsMOD
In this setting,your V995 will warn you
with an audible alert,and associated text
message stating which band has changed
from the original factory setting (i.e."SWS
ON").This warning is displayed during the
start up sequence (standard or fast).
WARNING: Do not turn off a band
unless you are absolutely certain that
there are no traffic radar units using
that specific band in your area.
16

Technical Details

Features and Specifications
Operating Bands
• X-band 10.525 GHz ± 25 MHz
• K-band 24.150 GHz ± 100 MHz
• Ka-band 34.700 GHz ± 1300 MHz
• Laser 904nm,33 MHz bandwidth
Radar Receiver / Detector Type
• Superheterodyne,VTO
• Scanning Frequency Discriminator
• Digital Signal Processing (DSP)
Laser Detection
• Quantum Limited Video Receiver
• Multiple Laser Sensor Diodes
Display Type
• 280 LED Alphanumeric
• Bar Graph
• 3 Levels of Brightness,plus Dark Mode
Power Requirement
• 12VDC,Negative Ground
• Power cord (included)
Programmable Features
• Power-On Indication
• Voice Alerts
• Power-On Sequence
• Signal Strength Meter
• AutoMute
• City Mode Sensitivity
• Radar / Laser Bands
Sensitivity Control
• Highway,AutoScan and City
Auto Calibration Circuitry
VG2 Immunity
Dimensions (Inches)
• 1.25 H x 2.75 W x 4.75 L
17