Alpine HVS-HF01 SMART MAP PRO Owner's Manual page 41

Special Settings
4
Select "SPECIAL" and press EN-
TER.
ENTER
5
The special use list appears.
Select the desired item and press
ENTER.
L Setting the point to avoid (POINT TO
AVOID)
This is set when there is a point that you do
not want to be covered by route searches.
Routes are set to avoid roads between
crossroads surrounding that point.
Five locations can be set. (From X0 to X4
can be displayed on the memory point list.)
L Setting the point to beep (POINT TO BEEP)
You can set the system to beep when you
are driving and approaching a point requir-
ing particular care (such as a point where
accidents occur frequently).
Up to ten locations can be set including the
beep direction points (from B0 to B9).
6
The special use setting list is
displayed. Press ENTER.
ENTER
7
The memory editing list is dis-
played.
L Setting the travel direction to beep (BEEP
DIRECTION)
For details on how to set the direction, see
Page 59 Direction correction.
A point for the system to beep at and the
direction of travel can be registered to-
gether. For example, you can set the system
to beep near Spandau only when travelling
from Berlin toward Hannover.
Up to ten locations can be set as directional
beep points and beep points (from B0 to B9).
L Not used (NO SETTING)
Use to cancel selected avoid points/beep
points/directional beep points.
41