Table of Contents
Advertisement
6.
iBTN RAID setting (3-pin IBTN_SEL1)
This jumper allows you to select the RAID configuration utility to use when
you create disk arrays. Place the jumper caps on pins 1–2 if you install a
PIKE RAID card to the motherboard and want to use the LSI Logic MPT
Setup Utility (default).
•
LSI Logic MPT Setup Utility is available only when you install a PIKE RAID
card.
•
LSI Mega RAID 5 fucntion is available only when you place the iBTN to
I_BTN1 slot and install an optional ASUS PIKE RAID card.
7.
DDR3 voltage control setting (4-pin LVDDR3_SEL1; LVDDR3_SEL2)
These jumpers allow you to adjust the DIMM voltage. Set to pins 1–2 to
select 1.5V BIOS control, pins 2–3 to select 1.2V Force or 3–4 to select
1.35V Force.
ASUS TS500-E6/PS4
4-7
Advertisement
Table of Contents
