Kyocera ECOSYS FS-1320D User Manual page 62

Target too long
The base data was so long that it could not be accommodated by the selected
barcode even following optimised compression.
Wrong data size
You requested QR Code or Datamatrix to use a specific maximum size or a set
symbol format. However, they were not able to accommodate the extent of the base
data. Reduce the amount of base data or select a different symbol size.
Unknown Kanji
A Kanji character represented by two bytes occurred in the base data for the QR
Code, the encoding of which did not conform to the rules of the JIS Shift 0208
standard.
Comma expected
In the Australia Post 4-state barcode the DPID has to be separated from the
customer information by a comma. The base data did not contain a comma.
Wrong DPID
Only eight-character digits are accepted as the DPID In the Australia Post 4–state
barcode.
Wrong space
The base data is not allowed to start with a space character in the Australia Post 4–
state barcode.
No N encoding
N encoding is not possible as characters other than the digits 0 to 9 occurred in the
base data.
Encoding choice
You have selected an encoding in the Australia Post 4-state barcode in which the
customer information cannot be represented.
Module too big
You have attempted to select a module size of over 1000 dots for a matrix code.
62