Motorola 9000SM - Canopy 900 MHz Subscriber Module User Manual page 3

Product Details for Products Tested for Compliance with Relevant EC Directives
(At this time, only the 5.7 GHz product has been tested for compliance with relevant EC directives.)
Operating
Frequency Range
Access Point 5.725 to 5.825 GHz
Subscriber 5.725 to 5.825 GHz
Module
Subscriber 5.725 to 5.825 GHz
Module with
Reflector
Backhaul 5.725 to 5.825 GHz
Backhaul 5.725 to 5.825 GHz
with Reflector
Exposure Note
The Canopy Subscriber Module (SM) must be installed to provide a separation distance of at least
20 cm (7.9 in) from all persons, when adding the Canopy reflector dish (in the 5.7 GHz band), the
reflector dish must be installed to provide a separation distance of at least 1.5m (59.1 in) from all
persons and does not emit a RF field in excess of Health Canada limits for the general population;
consult Safety Code 6, obtainable from Health Canada's website http://www.hc-sc.gc.ca/rpb.
In both configurations the maximum RMS power does not exceed 200mW.
The applicable power density exposure limit is 10 Watt/m
the ICNIRP guidelines, and the Health Canada Safety Code 6. The corresponding compliance
distances referenced above have been determined by assuming worst-case scenarios. The peak
power density ( S ) in the far-field of a radio-frequency source with rms transmit power P and
antenna gain G at a distance d is
In the case of the Canopy SM without reflector, the gain is 8 dBi (a factor of 6.3), so the peak
power density equals the exposure limit at a distance of 10 cm. A four-fold additional compliance
margin is artificially introduced by doubling the distance to 20 cm.
In the case of the Canopy SM with reflector, the gain is 26 dBi (a factor of 400), so the peak power
density equals the exposure limit at a distance of about 80 cm. An almost four-fold additional
compliance margin is artificially introduced by defining the compliance distance of 1.5 m. The
compliance distance is greatly overestimated in this case because the far-field equation neglects
the physical dimension of the antenna, which is modeled as a point-source.
Software License Terms and Conditions
ONLY OPEN THE PACKAGE, OR USE THE SOFTWARE AND RELATED PRODUCT IF YOU
ACCEPT THE TERMS OF THIS LICENSE. BY BREAKING THE SEAL ON THIS DISK KIT /
SM User Manual Issue 2
Maximum Effective
Transmitter Isotropic
Power Radiated
Power (EIRP)
200mW RMS 1 Watt EIRP
200mW RMS 1 Watt EIRP
200mW RMS 63 Watts EIRP
200mW RMS 1 Watt EIRP
200mW RMS 63 Watts EIRP
2
, according to the FCC OET Bulletin 65,
⋅
P G
=
S
π
d
Modulation Channel
Type Spacing
High Index 25 MHz
BFSK 20 MHz
High Index 25 MHz
BFSK 20 MHz
High Index 25 MHz
BFSK 20 MHz
High Index 25 Mhz
BFSK 20 MHz
High Index 25 MHz
BFSK 20 MHz
Page 3 of 34