Motorola 9000SM - Canopy 900 MHz Subscriber Module User Manual page 23

is a means for the Canopy System operator to segregate an individual network or neighboring
Canopy networks. Also, color code can be used to force a subscriber module to only register to a
specific access point module even though the subscriber module may be able to see multiple
access point modules. The default value for this parameter is 0 on all Canopy modules.
Display-Only Password: enter the same password in both fields for verification. The display-only
password, when used, will allow only view activities to the module. When the display-only
password is set and not the full-access password, the display-only password will be tied to telnet
and FTP sessions to the module. If the full-access password is also set then it has precedence on
the telnet and FTP sessions. If the password is forgotten, the operator will need physical access to
the module and will need to create a Canopy "default plug" to override the unit. See steps at end of
section for use and creation of a default plug.
Full-Access Password: enter the same password in both fields for verification. The full-access
password, when used, will allow view and change activities to the module. When the full-access
password is set, the password will also be tied to telnet and FTP sessions to the module. When
prompted for the password via the web-based interface, there is no username required; however
when prompted for the password via a telnet or FTP session, the user that MUST be used is "root".
If the password is forgotten, the operator will need physical access to the module and will need to
create a Canopy "default plug" to override the unit. See steps at end of this section for use of a
default plug.
Webpage Auto Update: enter time period (in seconds) desired to have the web browser refresh
the web-based interface. The default setting is 0, which will cause the web-based interface to
never refresh.
SM Power Up Mode with No 802.3 Link: choose which mode the module will default to when
there is no Ethernet connection sensed by the module. There are two modes available, the first is
Alignment mode and the second is Operational mode. See Alignment section for more information.
Operational Mode is the default setting.
Bridge Timeout Entry: choose the appropriate bridge timeout for correct network operation with
existing network infrastructure.
Authorization Key: each module ships with a unique, pre-programmed authorization key that is to
be utilized when an operator configures the Canopy System for DES encryption of the over the air
link. The default key is permanently stored on the module.
Site Name: enter information relating to a name given to the physical module. This parameter will
set the supplied information into the sysName SNMP MIB-II object and can be polled by a SNMP
management server. The buffer size for this field is 128 characters.
Site Contact: enter contact information relating to the module. This parameter will set the
supplied information into the sysContact SNMP MIB-II object and can be polled by a SNMP
management server. The buffer size for this field is 128 characters.
Site Location: enter information relating to the physical location of the module. This parameter
will set the supplied information into the sysLocation SNMP MIB-II object and can be polled by a
SNMP management server. The buffer size for this field is 128 characters.
Save Changes: by clicking on this button, any changes that have been made on the Configuration
page will be committed to flash memory and will take effect after the next module reboot.