Installation Of The Subscriber Module - Motorola 9000SM - Canopy 900 MHz Subscriber Module User Manual

discern that a password is set.
•
The operator can enter in information about the Site Name, Location, and Contact. This is
optional.
If the subscriber module is in the 5.7 GHz band and the operator will be utilizing the Canopy
passive reflector to obtain a link at distances of 10 miles or less, the subscriber module should be
mounted to the reflector in the following manner. The reflector arm is molded to receive the plastic
housing of the subscriber module. Utilize stainless steel hose clamps to secure the module to the
arm. The module is now properly aligned within the reflector.

INSTALLATION OF THE SUBSCRIBER MODULE

When power is applied to a Canopy module or the unit reset via the web-based interface, the
module will take approximately 25 seconds to boot up. During this boot up time, power on self-
tests and other diagnostics are being performed.
The following steps must be performed for successful installation:
•
Select a mounting location that is free from objects, such as buildings, large trees, etc., that
will interfere with the line of sight to the Access Point cluster location. Be mindful of the
Fresnel Zone.
•
The Canopy module should be mounted vertically as shown in FIGURE 3. All Canopy
modules' antennas are vertically polarized in this direction.
•
Mount the Canopy subscriber module to a secured location on the side/roof of the building.
The mount must be rigid and the subscriber module must not sway from outside forces.
•
Illustrated in FIGURE 3 is an example of mounting the unit to an antenna mast. Stainless
steel hose-clamps, or any suitable outdoor equivalent, may be used to secure the unit to
the mast.
SM User Manual Issue 2
Stainless steel
hose clamps
Reflector dish arm
Page 13 of 34