Table of Contents
Advertisement
LaCie 5big Network 2
User Manual
4.16.1. Connecting an External Hard Drive
You can connect an external USB or eSATA hard disk or USB key
to back up the data on your LaCie 5big Network 2 or as a way to
add storage capacity. Connected hard disks are accessed similarly
to shared folders.
TECHNICAL NOTE:
External USB or eSATA hard disks must be for-
matted in one of the supported systems to be compatible with the La-
Cie 5big Network 2: MS-DOS (FAT32), NTFS, HFS+ (non-hournaled
only), EXT3, or XFS.
To connect an external hard disk:
1. Make sure that your LaCie 5big Network 2 is connected to your
home network.
2. Turn on the external hard disk and connect its USB or eSATA
cable to the USB port (type A; see
Network 2
(Fig.
74).
3. In a few seconds, the disk should appear as a share in LaCie
Network Assistant and in the Dashboard. To access the files
on the hard disk, connect to it like a regular shared folder as
described in section
3. Accessing and Transferring Files
nected USB hard disks are always Public shares and are there-
fore Read-Write for all users).
To eject an external hard disk:
To unmount an attached USB hard drive, click the
IMPORTANT NOTE:
The maximum capacity supported for an ex-
ternal drive formatted in MS-DOS (FAT32) is 500 GB. In case the
capacity of the connected external drive exceeds this limit, the drive
will not be recognized by the 5big Network 2.
• DESIGN BY NEIL POULTON
Fig.
74) on the LaCie 5big
(con-
Eject
button.
Administering Your LaCie 5big Network 2
External USB
Hard Disk
Fig. 74
page 52
Advertisement
Table of Contents
Troubleshooting
