LaCie 301160U - 1TB Ethernet Disk RAID Network Attached Storage User Manual page 20

LaCie Ethernet Disk RAID
User Manual
4. Click Next to accept the default name (Storage), or
enter a name you prefer and then click Next. The
name can be up to 15 characters long and can include
letters, numbers, and hyphens. When you click Next,
the Date/Time
5. Specify the current date, time, and time zone, and
then click Next. The time should be expressed in
24-hour format. For example, 2:00 P.M. would be
entered as 14:00:00. When you click Next, the
work Settings
6. By default, if your network has a DHCP server, the
Ethernet Disk RAID obtains its IP address from
that server.
If your network does not have a DHCP server, the
default IP address and subnet mask are used. (The
default IP address is 192.168.0.101, and the default
subnet mask is 255.255.255.0.).
To accept the default settings, click Next. Otherwise,
specify the desired settings and then click Next.
When you click Next, the
appears (see Fig. 4.4.E.). (The options that appear
on this page vary, depending on the number of hard
disks that are currently installed in the system.)
7. If you want to add or remove hard disks, do so one at
a time and click
To accept the default disk configuration, RAID 5,
click Next.
RAID 5 provides the highest level of data protec-
tion, while RAID 5+ Spare provides the same pro-
tection and automatic data rebuilding in the event of
a disk failure.
If you want to change the disk configuration, select
the desired RAID level and then click Next. (For de-
tailed information about the different RAID levels,
refer to section
page appears (Fig. 4.4.C.).
page appears (Fig. 4.4.D.).
Disk Configuration
Scan after each action.
10. RAID and Storage Policies.)
Configuring Your Ethernet Disk RAID
Net-
Fig. 4.4.C.
Fig. 4.4.D.
page
Fig. 4.4.E.
CAUTION:
tions do not offer any data protection. If you lose a
hard disk, data loss will occur.
page 0
RAID 0 and linear disk configura-