IBM 622138U - IntelliStation Z - Pro 6221 User Manual page 63

16. Reconnect the external cables and power cords; then, turn on the attached
devices and the computer.
Replacing a diskette drive in bay 3
Complete the following steps to replace a diskette drive in bay 3:
1. Follow the instructions in "Preinstallation steps" on page 39.
2. Turn off the computer and all attached devices.
3. Disconnect all power cords; then disconnect all external cables.
4. Remove the side cover (see "Removing the side cover" on page 31).
5. Remove the bezel (see "Removing the bezel" on page 32).
6. Remove the support bracket (see "Removing and installing the support
bracket" on page 33).
7. Remove the existing drive by disconnecting the cables in the rear of the
diskette drive; then, press on the oval cutout to release the drive and gently
pull it out the front.
8. Remove the retainer from the left side of the diskette drive and place it on the
new diskette drive.
9. Install the diskette drive by sliding the drive into the bay so that the metal tab
of the drive aligns with the oval cutout and the drive locks into place; then,
connect the cables at the rear of the drive.
10. If you have other options to install or remove, do so now.
11. Replace the support bracket (see "Removing and installing the support
bracket" on page 33).
12. Replace the bezel (see "Replacing the bezel" on page 52).
13. Replace the side cover (see "Replacing the side cover" on page 53).
14. Reconnect the external cables and power cords; then, turn on the attached
devices and the computer.
Installing a hard disk drive in bay 4, 5, or 6
Bays 4, 5, and 6 are in the drive cage. The drive cage is behind the front of the
adapter-support bracket.
Note: You might find it useful to work with the computer laying on its side.
Complete the following steps to install a drive in bay 4, 5, or 6:
1. Follow the instructions in "Preinstallation steps" on page 39.
2. Turn off the computer and all attached devices.
3. Disconnect all power cords; then disconnect all external cables.
4. Remove the side cover (see "Removing the side cover" on page 31).
5. Remove the support bracket (see "Removing and installing the support
bracket" on page 33).
Chapter 4. Installing options
41