Electrolux 57" Stainless Steel Gas Grill Use & Care Manual page 16

15
Using the Rotisserie & Side Burner
Rotisserie Lighting
Open the lid. Push and turn the control knob
counter clockwise to the "HIGH" position. Wait
5 seconds. Then press and hold the electronic
ignitor button. You'll hear a snapping sound. If
the burner does not light in 4 seconds, turn the
control knob to OFF and wait 5 minutes before
trying again. Once lit, turn the control knob to the
desired setting. (See Fig. 16)
(If the ignitor does not function, the burner can be
lit by holding a lit match to the burner while the
control knob is turned counter clockwise to
"HIGH".)
NOTE: After the first use the stainless steel
around the burner will darken. This is a normal
occurrence of the non-rusting, type 304
stainless steel used on the grill. The infrared
panel will also darken after initial use. This is a
normal occurrence.
Note: Do Not operate the main
burners and infrared back burner
at the same time.
Side Burner Lighting
Push and turn the control knob to the
"HIGH"position and immediately press and hold
the electronic ignitor button. You'll hear a snap-
ping sound. It may be necessary to hold the elec-
tronic starter button for about 4 seconds. If the
burner does not light in 4 seconds, turn the knob
to the "OFF" position and wait 5 minutes before
trying again. Repeat above steps to light remain-
ing burners. (See Fig. 18)
Match Lighting
If by chance the electronic ignitor does not light
the burner, the burner may be lit with a match.
Keep your face as far away from the burner as
possible and place a lit, long stem match through
the spaces in the grate to the ports of the burner.
Position the match near the burner ports and push
and turn the control knob to the "HIGH"position.
(See Fig. 17)
15
Fig. 16
Fig. 17
Fig. 18