JVC DR MV79B - DVDr/ VCR Combo Instructions Manual page 66

Thank you for your purchase of the JVC DR-MV100B DVD Video Recorder.
If you have any questions regarding the hookup or operation of your DR-MV100B, please contact our
Customer Care Center at 1-800-252-5722.
Please Note:
Be sure to connect the AC power plug into the power outlet after all other connections are completed.
What DVDs can I use to record on my
DR-MV100B?
c DVD-R, DVD+R, DVD-RW and DVD+RW,
DVD-RAM can be used to record on your
DR-MV100B.
For recommended recordable DVD discs, please
refer to page 3 in your owner's manual.
When I turn on my DR-MV100B, it flashes
"Hello" and all the buttons on the remote
control and the front panel will not respond
for 10 - 15 seconds. Is this normal?
When your DR-MV100B is first turned on, it will flash
"Hello" as the internal EPROM chip is updated with
information.
c Please wait until "Hello" stops flashing before you
attempt to use the remote control or front panel
buttons. It takes 25-30 seconds until the set
can be operated when a disc is on the tray.
My DR-MV100B is showing a distorted
picture.
Your DR-MV100B has a progressive scan feature.
This feature only works with a TV that accepts a pro-
gressive scan signal.
c If the picture is distorted, press OUTPUT
STATUS button and select 480i.
When the resolution is set to 1080p in VCR
playback, the picture can be distorted.
c If the picture is distorted, press OUTPUT STATUS
repeatedly until the picture appears normally to
change the resolution setting.
For additional troubleshooting tips please refer to pages 49-51 in your owners manual.
JVC Customer Care Center
1-800-252-5722
DR-MV100B Quick Guide FAQ's
My DR-MV100B is showing no picture.
There is no signal output from COMPONENT OUT
when HDMI is connected and 720p/1080i/1080p is
selected at OUTPUT STATUS.
c Press OUTPUT STATUS button and select either
480i or 480p in order to watch the video signal
from COMPONENT OUT.
My newly recorded DVD plays in my
DR-MV100B but does not play in other DVD
players.
c You must "Finalize" the DVD before it can play in
another DVD player.
Please see page 21 in your owner's manual.
During the Initial Set Up, I am being asked
to set the Clock. Does this model have Auto
Clock Set?
This unit doesn't have an Auto Clock Setting. You will
need to manually set your clock as shown on page
14 of your owner's manual under the Initial Setup
Wizard. You can also look on page 16 of your
owner's manual and follow the directions for Clock
Set.
LVT1903-001A
0308SKMLGEEGL