Connections To Your Tv - JVC DR MV79B - DVDr/ VCR Combo Instructions Manual

Connections to your TV

Connections to your TV
Make one of the following connections, depending on
the capabilities of your TV.
RF coaxial connection
Connect the ANTENNA OUT jack on the Recorder to
the antenna in jack on the TV using the supplied 75-
ohm Coaxial Cable (R).
Video connection
Connect the VIDEO OUTPUT jack on the Recorder
to the video in jack on the TV using the video cable
supplied (V).
Note:
If you use this connection, set the TV's source selector to
VIDEO.
S-Video connection
Connect the S-VIDEO OUTPUT jack on the Recorder
to the S-Video in jack on the TV using the optional
S-Video cable (S).
Component Video connection
If your television is a high-definition or "digital ready"
television, you may take advantage of the Recorder's
progressive scan output for the highest video resolu-
tion possible.
Connect the COMPONENT OUTPUT jacks on the
Recorder to the corresponding in jacks on the TV
using an optional Y P
10
P cable (C).
B R
Notes:
• Set the resolution to 480p using OUTPUT STATUS but-
ton on the front panel for progressive signal.
• Progressive Scan does not work with the RF, Video or
S-Video connections.
• If your TV does not accept the Progressive Scan format,
the picture will appear scrambled.
• If the resolution is set to 720p, 1080i or 1080p, the
VIDEO OUTPUT, S-VIDEO OUTPUT and COMPO-
NENT OUTPUT connections are not available.
Audio connection
Connect the Left and Right AUDIO OUTPUT jacks on
the Recorder to the audio left/right in jacks on the TV
using the supplied audio cables (A1 or A2).
Rear of TV
S-VIDEO
INPUT
S
Rear of Recorder
R
Rear of TV
COMPONENT/PROGRESSIVE SCAN
AUDIO INPUT
VIDEO INPUT
R L
Y
Pr Pb
C A2
V A1