Resetting The Recorder - JVC DR MV79B - DVDr/ VCR Combo Instructions Manual

Symptom
Can't play disc recorded
on this Recorder on
another DVD player.
Cannot record or did
not record successfully.
Stereo Audio Record
and/or Playback not
present.

Resetting the Recorder

If you observe any of the following symptoms...
• When the Recorder is plugged in, but the
power will not turn on or off.
• When the display window is not working.
• When the Recorder does not operate
normally.
Cause
The disc was recorded in Video mode.
Some players will not play even a
finalized disc recorded in Video mode.
The disc was recorded in VR mode.
Discs recorded with copy-once materi-
al cannot be played on other players.
The remaining blank space on the
disc is insufficient.
The source you are trying to record is
copy-protected.
When recording to a Video mode disc,
programs that are copy-once protect-
ed cannot be recorded.
TV is not Stereo-compatible.
Recorder A/V Out jacks are not
connected to TV A/V In jacks.
Recorder Audio/Video Out is not
selected for viewing at the TV.
Finalize the disc; see page 17.
No solution.
The other player must be RW
compatible in order to play it.
No solution.
Use another disc.
You cannot record the source.
Use a VR mode formatted disc for
copy-once material.
No solution.
Make A/V connections. Stereo is avail-
able only via A/V output from Recorder.
Select AUX or A/V source as TV input.
.
You can reset the Recorder as follows:
• Press and hold the STANDBY/ON button for
more than five seconds. This will force the
Recorder to power off.
Press the STANDBY/ON button again to turn
the Recorder back on.
• Unplug the power cord and then plug the
power cord again after more than five sec-
onds.
Correction
45