Installing The Display Driver; Enabling Sli Mode - Nvidia FX1300 - Quadro FX 128MB Dual DVI-I PCIe Video Card User Manual

The SLI connector is required for SLI Frame Rendering and SLI Antialiasing.
6 If your graphics boards have an auxiliary power connector, connect them to the
power supply using the supplied power connector cables.
7 Replace the system's cover and reconnect your display(s) to the SLI‐capable
graphics board installed in the x16 expansion slot.
8 Plug the power cable back into the system.

Installing the Display Driver

Follow the steps listed below to install your driver software:
1 Power on the system and log into Windows.
2 Cancel the Windows "Found New Hardware Wizard".
This message should appear twice – one for each graphics board).
3 Run "setup.exe" in the SLI driver you saved to your desktop.
4 Follow the "Next" prompts to proceed with driver installation.
5 Once the software has been installed, choose "Yes, I want to restart my computer
now" and select "Finish" to reboot the system.

Enabling SLI Mode

1 After logging back into Windows, you should see the message "SLI capable
system" in the bottom right corner of the screen.
2 Click anywhere on the message.
If the message disappears, continue with the following steps.
3 Right click the desktop and click Properties‐>Settings‐>Advanced, then click the
Quadro FX product tab.
NVIDIA Corporation
Chapter 8
Using NVIDIA SLI Technology
160