Using The Neoware User Interface Selection Wizard; Set Up With The Thin Client User Interface - Neoware e140 - Thin Client User Manual

Configuring Your Neoware Appliance
Using the Neoware
User Interface
Selection Wizard
Set up with the Thin
Client User
Interface
22 Selecting the Initial Configurations
If it uses DNS, what are the IP addresses of the primary and
secondary DNS servers and the default domain name?
___.___.___.___, ___.___.___.___, __________________
If it uses WINS, what are the IP addresses (if any) of the pri-
mary and secondary WINS servers?
___.___.___.___, ___.___.___.___
The Neoware User Interface Selection Wizard guides you through
the process of configuring your Neoware appliance. The Selection
Wizard appears either when the Neoware appliance starts for the
first time, or when it has been reset to factory-default settings. There
is a quick guide showing you how to reset the appliance later in this
chapter (see "Quick Guide to Resetting the Terminal to Factory
Default Settings" on page 30.) or more complete reset instructions in
Chapter 6 - Changing Appliance Properties. (see "The General tab"
on page 87.)
Setting up your thin client and creating server connections is a sim-
ple process that is outlined in the chapters below. Configuring your
appliance takes only a few steps to complete.
1
Turn on or reset Neoware appliance.
2
When the Neoware User Interface Selection Wizard appears
it will default to "Thin Client User Interface". You can con-
figure your appliance to either the common thin client inter-
face or to the Windows CE desktop interface.