Storing Scene Files And Other Settings On Memory Cards - Panasonic AG-AC130A Operating Instructions Manual

Storing scene files and other settings on memory cards

You can save up to four scene file settings or other
settings as files on a memory card, and you can
also load them from the memory card.
• In the case of the scene files, the current settings
are automatically saved in the camera, and the
saved data is written on a memory card. When
the data has been read from a memory card, the
current settings are rewritten at the same time as
the data saved inside the camera.
• The data in all the scene files, <F1> to <F6> is
rewritten.
The following description basically describes
storing scene files.
1
Turn the POWER/MODE switch of the
camera <ON>. (Page 27 of Vol.1)
2
Select the slot number for the memory card
onto which you wish to save from the [CARD
WRITE] item on the setup menu [SCENE
FILE] screen, and push the OPERATION
lever.
For other settings, select the [USER FILE]
screen. (Page 92)
• Menu operation (Page 28 of Vol.1)
• Operations may be performed with buttons on
the remote control that correspond to those on
the camera. For details, see "Remote control"
(Page 21 of Vol.1).
42
3
Tilt the OPERATION lever in the < >< >
< >< > directions, select a file, and push
the OPERATION lever to set the file name.
4
Push the OPERATION lever again, select
[YES] when the following screen appears,
and push the OPERATION lever.
• In the following example, [SCENE-01] is the
TITLE name. To change the TITLE name, see
the following description.
• "FILE 1 (file name) WRITE COMPLETED" is
displayed when writing is complete.