Adjusting The Shutter Speed; Using The <Shtr> Dial; Setting The Shutter - Panasonic AG-AC130A Operating Instructions Manual

Adjusting the shutter speed

Using the <SHTR> dial
1
Press the <DIAL SEL> button.
• The role of the <SHTR> dial changes in the
following order.
[DIAL SHUTTER][DIAL SYNCHRO
SCAN][DIAL LOCK]
• To select [DIAL SYNCHRO SCAN], press
the <DIAL SEL> button and select [DIAL
SHUTTER], and turn the <SHTR> dial to set
the synchro scan.
• After approximately 12 seconds without
a dial operation, [DIAL LOCK] will be set
automatically. To operate the camera again,
press the <DIAL SEL> button. The camera
resumes the last operated mode. You can also
use the <DIAL SEL> button to set [DIAL LOCK]
in order to prevent unintentional operation.
34
<DIAL SEL> button
<SHTR> dial

Setting the shutter

1
Press the <DIAL SEL> button and select
[DIAL SHUTTER].
2
Press the <SHTR> dial.
• Each time the <SHTR> dial is pressed, the
shutter will turn ON/OFF.
• The shutter speed is changed in the order
shown in the charts on page 35 by turning the
<SHTR> dial when the shutter is ON.
• Remember that the faster the shutter speed,
the lower the camera sensitivity.
• Focusing on the subject would take longer if
the shutter speed is reduced, it is therefore
recommended that the camera be secured to
a tripod, etc. during shooting.
• Under the lighting of electric discharge tubes
such as fluorescent lamps, horizontal bands
may appear on the screen. Adjusting the
shutter speed may improve this condition.
• A subject that quickly crosses the camera may
appear distorted when shot. This is due to the
signal reading system of the pickup devices
(MOS sensor), and is not a defect.
• At slow shutter speeds (1/6 to 1/15), white,
red, green, or blue dots may appear on the
screen, however, this is not a defect.