What Next - HP C7401A - SureStore Ultrium 230 Tape Drive Technical Reference Manual

stape card instance 0 SCSI target 6 SCSI LUN 0 berkeley no rewind
BEST density at address 2/0/1.6.0 /dev/rmt/4mnb

What Next?

16 HP-UX Systems
This should produce the following output to show that the device file now
exists:
To create a device file for Ultrium in uncompressed mode, you should use a
command such as:
mksf -H -a -b U_18
and for compressed mode (default):
mksf -H -a -b U_18C
The hardware path can be found from previous
Once the device files have been created, you should confirm that your new
tape drive is working properly.
provides instructions on backing up and restoring a sample file to test your
installation.
ioscan
Chapter 6, "Verifying the Installation"
output.