HP C7401A - SureStore Ultrium 230 Tape Drive Technical Reference Manual page 12

target 1 8/16/5.5
disk 0 8/16/5.5.0
target 2 8/16/5.7
ctl 2 8/16/5.7.0
processor 0 62
memory 0 63
tape 4 2/0/1.5.0
12 HP-UX Systems
tgt CLAIMED
sdisk CLAIMED
tgt CLAIMED
sctl CLAIMED
processor CLAIMED
memory CLAIMED
After you have installed the new tape drive, you can check that it has been
attached successfully. From a shell window (
to display the list of attached devices.
ioscan
For an HP Ultrium drive, execute the following:
% /sbin/ioscan -f | grep "Ultrium"
The new lines should look similar to the following, where the
represents the instance of the SCSI tape driver, not the SCSI ID:
stape CLAIMED
Note If you are installing the drive onto a Storage Area Network
(SAN), the fibre channel/SCSI bridge will also appear in the
list of attached devices.
If you cannot find the Ultrium drive, this may be because the kernel does not
contain the correct driver. Use the System Administration Manager (
add to the kernel:
stape
To add to the kernel using
stape
1
% sam
2 Select the following:
Kernel Configuration
Drivers
Highlight the
3
stape
both Current State and Pending State will read "Out".
4 Select the following:
Actions
Add Driver to Kernel
The Pending State will now read "In".
5 To add the new driver to the kernel, select:
DEVICE
DEVICE SEAGATE ST34573N
DEVICE
DEVICE Initiator
PROCESSOR Processor
MEMORY Memory
hpterm/xterm
DEVICE HP
:
sam
driver. If the driver has not been added to the kernel,
), execute
in the field
4 I
Ultrium
) to
sam