Hp-Data Values - HP C7401A - SureStore Ultrium 230 Tape Drive Technical Reference Manual

tape-config-list =
"HP Ultrium 1", "HP
HP_LTO_GEN_1 =,0x3B,0,0x18659,4,0x40,0x40,0x40,0x40,3,60,300,600,1200,600,600,18000;
name="st" class="scsi"
target=X lun=0;

HP-Data Values

for Solaris 9:
Ultrium LTO 1", "HP_LTO_GEN_1",
where is the SCSI target address of the device you have attached.
X
See "HP-Data Values" on page 27
in these lines.
2 If you are replacing an existing tape device on the same SCSI ID, remove
the contents of the
/dev/rmt
% cd /dev/rmt
% rm *
Do a reconfigure boot:
3
% cd /
% touch /reconfigure
% sync;halt
4 When the system is down, reboot:
% boot -r
Make sure you include the
reconfigured using the new data.
You should now be able to use the drive.
5
Use
—
/dev/rmt/Xcb
where is the relevant device address.
X
— Use
/dev/rmt/Xcbn
device.
Once the device files have been created, you should confirm that your new
tape drive is working properly.
provides instructions on backing up and restoring a sample file to test your
installation.
The values for
HP_LTO_GEN_1
have the following meanings:
below for the values of the parameters
directory as follows:
switch, so that the device directory is
-r
if you require a compression rewind device file,
when you require a compression non-rewind
Chapter 6, "Verifying the Installation"
and , which provide normal LTO mode,
name
Sun Systems, Solaris (SunOS 5.x) 27