Using The Ac Adaptor - Panasonic Lumix DMC-GH1K Operating Instructions Manual

Using the AC Adaptor

You can use the camera without worrying about battery discharge when it is connected to
a PC or a printer if you use the DC cable to connect the camera to the battery charger/AC
adaptor and connect the AC cable.
• Check that the camera is turned off.
• Close the flash.
Connect the AC cable.
Connect the DC cable A.
• Pull open the DC cable cover 1 and then
connect the DC cable to the camera body using
the same steps as "Inserting/Removing the
Battery" (P24). Pull the DC cable through the
opening as shown in the illustration and then
close the battery door.
• Be careful not to catch the DC cable when
closing the battery door.
• You cannot charge the battery if you connect the
DC cable.
Note
• Do not use any other AC cables except the supplied one.
• Do not use any other DC cables except the supplied one. If you use other DC cables, it may
cause a malfunction.
• The camera becomes warm during use. This is not a malfunction.
• Disconnect the charger/AC adaptor and DC cable when the camera is not in use.
• It is recommended to use a fully charged battery or AC adaptor when recording motion
pictures.
• If while recording motion pictures using the AC adaptor the power supply is cut off due to a
power cut or if the AC adaptor is disconnected etc., the motion picture being recorded will not
be recorded.
• The unit is in the standby condition when the AC adaptor is connected. The primary circuit is
always "live" as long as the AC adaptor is connected to an electrical outlet.
Preparation
25
VQT2A61