Download Print this page

Dell PowerEdge 2600 Installing Or Replacing Manual page 8

Era/o card
Hide thumbs Also See for PowerEdge 2600:

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Reinstall the expansion-card guide:
8
a
b
F i g u r e 1 - 5 .
tabs (2)
Reinstall expansion cards that you removed:
9
a
b
c
d
1-6
I n st al ling or Re p la c in g a n ER A/ O Ca r d
Holding the expansion-card guide at a 45-degree angle, insert the two tabs at the
ends of the expansion-card guide base into the slots on the system board. See
Figure 1-5.
Rotate the expansion-card guide down until the clip snaps securely onto the
system board.
R e i n s t a l l i n g t h e E x p a n s i o n - C a r d G u i d e
slots (2)
Position the expansion card so that the card-edge connector aligns with the
expansion-card connector on the system board. See Figure 1-2.
Insert the card-edge connector firmly into the expansion-card connector until the
card is fully seated.
When the card is seated in the connector, close the expansion-card latch.
NOTE: SCSI cables connected from an expansion card to the SCSI backplane
board should be routed under the front fan assembly.
Reconnect all expansion-card cables.

Advertisement

loading