Dell PowerEdge 2600 Installing Or Replacing Manual page 10

Removing an ERA/O Card
NOTICE: Do not attempt to disconnect the ERA/O card from the connector on the
system board until you have unfastened the card from each of the four support posts.
Unfasten each of the support posts from the card:
1
a
b
Lift the ERA/O card straight up and out of the chassis.
2
F i g u r e 1 - 7 .
system board
ERA/O card
connector
1-8 I n st al ling or Re p la c in g a n ER A/ O Ca r d
Compress the clasp at the top of the support post while carefully lifting up on the
corner of the card to unseat the post. See Figure 1-7.
Repeat step a for each support post.
R e m o v i n g a n E R A / O C a r d
ERA/O card
mounting holes (4)
support posts (4)