Dell PowerEdge 2600 Installing Or Replacing Manual page 5

Remove any full-length expansion cards. If you do not have any expansion cards
5
installed, skip to step 6.
Unfasten and remove the expansion-card latch. See Figure 1-2.
a
Disconnect any cables attached to the card.
b
Grasp the expansion card by its edges, and remove it from the expansion-card
c
connector on the system board.
F i g u r e 1 - 2 . R e m o v i n g a F u l l - L e n g t h E x p a n s i o n C a r d ( I f I n s t a l l e d )
expansion-card
latch
Installing or Replacing an E RA/O Card
1-3