Completing the installation
To complete the installation, complete the following steps:
1. If the bezel is open, insert the bezel hinges into the slots on the server chassis
2. Position the left-side cover over the server.
3. Place the bottom edge of the cover onto the bottom edge of the server.
4. Rotate the top edge of left-side cover toward the server; then, press down on
5. Rotate the bezel to its fully closed position.
6. Using the supplied key, lock the left-side cover and bezel.
7. Connect the cables and power cords. For more information, see "Connecting
Connecting the cables
Notes:
1. Be sure to turn off the server before you connect any cables to or disconnect
2. For additional cabling instructions, see the documentation that comes with the
3. Cable identifiers are printed on the cables that come with the server and
and close the bezel.
the cover handle until it clicks into place.
the cables."
any cables from the server or hot-plug adapter.
optional devices. It might be easier for you to route any cables before you install
certain optional devices.
optional devices. Use these identifiers to connect the cables to the correct
connectors. For example, the hard disk drive cables are labeled "HDD option."
Chapter 2. Installing optional devices
105