Table of Contents
Advertisement
j. If you are installing a 5.25-in drive in bay 2, push the drive into the bay until
it locks into place. If you are installing a 3.5-in drive in bay 2, attach the
5.25-in conversion kit and push the drive into the drive bay.
k. Connect power and signal cables to the drive and the connectors on the
system board. (See "System-board internal connectors" on page 23 and
"Internal cable routing and connectors" on page 38 for more information.)
l. Route the signal cable through the plastic slot on the bottom of the chassis
underneath the fan cage assembly so that it does not block the airflow.
m. Reinstall the fan cage assembly.
n. Reinstall the air baffle (see "Installing the air baffle" on page 61).
o. Rotate the power-supply cage assembly back into the server. Press the
power-supply cage release tab and rotate the power-supply cage assembly
into the chassis.
Chapter 2. Installing optional devices
73
Advertisement
Table of Contents
